R2 the battle bus

[S0updragon]

Oh how ironic, the only leak is from the water fill seal. About the only seal that hasn’t been replaced.

 

[Panky]

Best to find it now

 

[jimberlake]

that cause there's no end on it

 

[S0updragon]

Sides insulated yesterday and not a lot else done as the f@&% up fairy spent most of the day “helping”. Today much more constructive. New fixings for all the furniture sourced and seat frames and new bulkhead ready to prime and build. Just some hinged lids to go, oh and all the rest of the furniture

 

[Panky]

Looking good
Not sure if this will be of any use, scroll down to the bottom of the page

Downloads

Documents for the comemr including free Commer Manual

www.commervanfan.co.uk

 

[S0updragon]

I have original furniture to measure off but it never hurts to have an original plan. Screenshoted and saved. Thank you

 

[S0updragon]

Vinyl down and seat framed and bulkhead painted. Tomorrow square it all up and make the lids and start the cupboards

 

[S0updragon]

Seats finally built

 

[S0updragon]

Well nearly as I’ve forgotten to put the table supports on them to make the bed.

 

[Panky]

That does look nice, very well finished off - I like the corner edge treatment

 

[S0updragon]

They were freebie off cuts from local camper conversion company

 

[Panky]

We love free stuff

 

[S0updragon]

Oh yes

 

[S0updragon]

Seat backs on and can still get to the jack (phew)

 

[S0updragon]

Started the n/s furniture and decided to alter it a little at the back end. And put drawer runners on which make tolerances unforgiving but it should work. Held together with dowels and hopefully tomorrow get the last panels done. All seems good so far. Maybe just gave a big hinged top and forget about the cupboard doors lol

 

[S0updragon]

Drawers are in and actually work. Back of hob done. Bench end done. Just the door end to do tomorrow. Oh and cut out all the doors and drawer fronts and paint and screw it together

 

[S0updragon]

Well nearly there on the n/s bit. Finishing off the edges and then some painting. I know I’ve sacrificed the back cupboard and turned it into a gas bottle cupboard and a shelf

 

[S0updragon]

Worktop hob bit needs cutting out and then that’ll be ready to go on.

 

[Panky]

That is excellent. Auto-Sleeper with a twist

 

[S0updragon]

I hope not or the doors will stick like the last furniture I made lol