Another Jennings resto

I've done a couple of small sections using a bead roller but the panel did distort quite badly (probably just me not making them big enough) but I got lovely door Botton repair sections from Martin Maltas.
Will be interesting to see the results if you go the power hammer rout.
 
I’ve got an English wheel i can use to pre stretch if i bead roll, I have the make it kustom (YouTube) profiler so would make a profile off the vehicle using a block of filler and transfer it onto 5mm steel to put in the machine. For what Martin charges for door bottoms I’d probably be better and easier to use those, but a big thing for me is doing as much as I can and learning as much as possible doing so
 
I approve your philosophy, I do what I can with limited equipment with sometimes questionable results ;)
 
The rear plate holder had taken a bash, cracked in a couple of places and a few bits missing. Could probably have fixed it, but I’m learning enough new skills as it is without needing to learn fibreglass ! So I set about remaking it out of steel. Happy with the outcome, it’s SLIGHTLY bigger overall but I’ll get it in the hole with a tweak to the surrounding timber. Better welding, some filler in the edges to tidy it up and it’ll be tip top
 

Attachments

  • IMG_0301.png
    IMG_0301.png
    1.7 MB · Views: 11
  • IMG_0300.png
    IMG_0300.png
    1.6 MB · Views: 9
Had another go at getting the profiles dialled in. Just did them freehand so they aren’t the straightest! Happy enough with how they’ve come out, I measured the gap between the centre of the profiles incorrectly (i have to do them 1 at a time) which is why it doesn’t quite match the mould. Turned out ok and hasn’t seemed to stretch the panel. I’ll make a fence of some sort to make straighter lines next time
 

Attachments

  • IMG_3163.jpeg
    IMG_3163.jpeg
    124.3 KB · Views: 4
  • IMG_3164.jpeg
    IMG_3164.jpeg
    157.1 KB · Views: 4
  • IMG_3165.jpeg
    IMG_3165.jpeg
    165.2 KB · Views: 5
  • IMG_3166.jpeg
    IMG_3166.jpeg
    133.2 KB · Views: 6
Still on the lookout for inner sills btw, martin is unable to male any for a month or 2. Planning how to tackle the inside, i think i’ll strip it all out as I’m pretty sure it needs a full floor replacement. Not sure how much of the original camper interior wooden cabinets I’ll be able to save/reuse, a lot of it is toast especially the 2 rear cupboards & inner wall cladding. Happy to hear any input on how to tackle the floor etc, do i need to support the camper body externally with axle stands or similar?
 
Back
Top