I think they might ...it depends whether they would accommodate the front hubs ......although wheel spacers/adapters can be made by Commeracer...I'm sure he will be along soon o give a more accurate opinion
''COMMER'EnSayThat''
A Commerless Guinea pig of The 6-Speed Club (Highly recommended)
The PCD is correct but not sure about the off-set, also I think the centre hole will need opening up to go over the front hub bearing housing. It will be a bit of a squeeze getting them on the rear as well, not much clearance with the inner cill
Well said Panky[8D] ......I suppose anything is possible regarding the rears, You could reconstruct the inner sills and chassis as long as it would take away no chassis strength and make some hinged body panels to allow for easy removal/fitting of the wheels ....probably not worth the effort ...depends on your budget and capabilities ...and how much you are fussed with originality .....
''COMMER'EnSayThat''
A Commerless Guinea pig of The 6-Speed Club (Highly recommended)
Those should fit ok on the rear, the front might need a spacer, but they are not too wide so should clear most things. Why they have squeezed a 245 on a 6" rim is anybodys guess
"You,re only supposed to blow the bloody SLIDING doors off"
Founder of the 6 speed club
I recon they will hit the rear leaf spring as there 4 inch off set so there to far in if that makes sense. The front will need the centres opening out like been said before. All that said they will go on with some messing about ive got 9j on the back
JON'S AUTOS the garage that comes to you... [email protected]
www.jonsautos.co.uk
www.facebook.com/jonsautos