Underframe protection

no it cant :(, hammerite is excellent stuff but is brittle and will not take the grit blasting that underframes get, it lasts about a year at most. i use waxoyl underbody seal,its hard to beat and well worth the cost [^]

"you were only supposed to blow the bloody doors off no.3"
 
I have used both in the past and agree with Tim. The Hammerite was ok for a while, but was liable to chip and then blister when rust set in. Hammerite can be messy to apply, but works a treat. All the preparation you need is to clean the suface to be protected and cover up your brakes.
I have also heard good reports of Dinitrol, but have never used it.
 
the better you prep the surface the better waxoyl works, same as everthing else. so long as the surface is clean and all the rust treated first then its like painting with tar/bitumen.:)

"you were only supposed to blow the bloody doors off no.3"
 
10 points to those who spotted my deliberate mistake! [:eek:)]

I meant to say that Waxoyl can be messy to apply, but I used a hand pump spray thingy and warmed up the Waxoyl. Brushing it on sounds much cleaner.:)
 
You could also sandblast/wire brush, prime, shutz, 3 coats of paint and then waxoil :I

IMG_4438.jpg


IMG_4427.jpg
 
Looks a bit too yellow to be the detector van, and no marks from a fork lift truck anywhere [:0]. If it's the BT van it's got to be the quickest resto on record.

'Harvey the RV'
 
Ive been told waxoyl is ideal for treating wood as well, anybody confirm this for me please, as im wanting to treat the wooden timbers of my Bedford floor and chassis.
:D


Its bound to give you trouble!..thats what you asked for though isnt it!???
 
Back
Top