Seatbelt mounting points

Paul Goldsmith

Paul Goldsmith

0
Previously I fitted Securon 3 point inertia sealtbelts to my Commer PB but they were removed many years ago. Apart from the 3 upper mounting holes on the door post I no longer recall how these were mounted, I've searched CVF but all the related posts are old and their images are lost. As there's no mention in 'Cab and Body' section 'O' in the workshop manual, would somebody be kind enough to enlighten me. Thanks !
 
The reel would have been mounted down by the hand brake and the stalk on the edge of the engine bay lip, I'll see if I can get some pics later.
 
You're a star as always, thanks Panky !
I'd forgotten about those captive nuts way back behind the seats, that's what I couldn't fathom out.
Strangely I've got an extra bolt hole about halfway up each door frame which seems seat belt sized, not sure whether that's strong enough but it might work for me putting the retracting bit there and just the other end behind the seats.
But at least I now have the third hole to play around with :cool:
 
Last edited:
This is the other hole that I was referring to.
I recall a domed nut on the outside but there is no captive nut on the inside, I'm struggling to remember what these were if not seatbelts ...

20190408_134006.jpg20190408_133943.jpg
 
Last edited:
Not a standard mounting point but looks strong except for the less than flat surface. Like I said earlier probably placed there because the webbing was too short on the reel. The ones I got had plenty of webbing so the reel is mounted down where it should be.
 
Thanks Panky, I'm using Securon 500s seatbelts which have plenty of webbing, so I'll set the passenger belt like yours and see which I prefer
 
You must log in or register to reply here.
Back
Top