P5 WHEELS

[supercoolcommer]

Hi, In need of assistance again. I have fitted rover P5 Rostyles to my camper, I obviously opened up the holes and the centre for the front which fit a treat, however, having fitted the rear ones, the wheels are sitting against the 5 raised squares on the brake drum, which results in the studs being shorter, and dodgy to drive. Im guessing im going to have to change the studs for longer ones and probably need spacers?? Any ideas on where I can geet some or any other ideas to solve the problem????
GAV.

So Super Cool

 

[macker1]

I must have a different rear axle as mine does not have any blocks on the rear, Sunbeam Sam advised me on these wheels and might be able to point you in the right direction. found out today that Dora has a 15 cwt rear axle hence no blocks

 

[commeracer]

could it be that you have different brake drums [?]

"you were only supposed to blow the bloody SLIDING doors off"

 

[sunbeamsam]

http://www.rallydesign.co.uk/product_info.php?cPath=731_736&products_id=4691

is i think what i ended up using (front and back)

 

[supercoolcommer]

Hi, they look perfect for the job. Is there enough room between the the wheel and the arch? Also I take it although the pcd is 127 they will fit no problem? Gav.




quote:
Originally posted by sunbeamsam

http://www.rallydesign.co.uk/product_info.php?cPath=731_736&products_id=4691

is i think what i ended up using (front and back)



So Super Cool

 

[supercoolcommer]

Front is perfect just the back that is a problem.


quote:
Originally posted by sunbeamsam

http://www.rallydesign.co.uk/product_info.php?cPath=731_736&products_id=4691

is i think what i ended up using (front and back)



So Super Cool

 

[supercoolcommer]

Hi Its just like 5 raised points on the drum itself. Like raised rectangle blocks. Could be that they are different drums?????




quote:
Originally posted by commeracer

could it be that you have different brake drums [?]

"you were only supposed to blow the bloody SLIDING doors off"



So Super Cool

 

[supercoolcommer]

Actually these would be better as they fit a range of pcd's

http://www.rallydesign.co.uk/product_info.php?cPath=731_736&products_id=4688





quote:
Originally posted by sunbeamsam

http://www.rallydesign.co.uk/product_info.php?cPath=731_736&products_id=4691

is i think what i ended up using (front and back)



So Super Cool

 

[sunbeamsam]

whoops! sorry clicked the wrong link, those are the ones i used. without them the tyres were very close (1cm) to the rear spings. with them the spacing is spot on.

 

[supercoolcommer]

Very much appreciated. You have saved me a lot of hassle...Are you tippin up to the meet?


quote:
Originally posted by sunbeamsam

whoops! sorry clicked the wrong link, those are the ones i used. without them the tyres were very close (1cm) to the rear spings. with them the spacing is spot on.



So Super Cool

 

[supercoolcommer]

Hi, Fitted one set to the rear so far as they only had one in stock[V], however fitted like a glove and should improve handling....hopefully???



quote:
Originally posted by sunbeamsam

whoops! sorry clicked the wrong link, those are the ones i used. without them the tyres were very close (1cm) to the rear spings. with them the spacing is spot on.



Super Super Cool

 

[sunbeamsam]

regrets, the revison monster is home this weekend and I'm not allowed out. Hopefully there will be another meet later in the year. Have fun!