Hot Wheels - Alloys

Yep they will fit early commers but not dodge as drums are bigger on the back;)
You may have to machine the centres out to get over the front hubs though.
There a bit like mine but mine are direct fit on a commer and have a deeper dish on the rim;)

IMG00014-20100718-1352.jpg


th_IMG00232-20100618-1221.jpg

th_icon_welder.gif
 
Stud pattern (pcd) should be the same, possible that the stud holes may be too large or too small though. You'd have to check.

BazRockscropped.jpg

Peggy drinks too much!
If I told you I was a pathological liar, would you believe me?
 
quote:
Originally posted by bazzateer

Stud pattern (pcd) should be the same, possible that the stud holes may be too large or too small though. You'd have to check.

BazRockscropped.jpg

Peggy drinks too much!
If I told you I was a pathological liar, would you believe me?




Stud holes will be fine but you must use the correct wolfrace nuts as they have a collar on them to fit into the stud hole;)

th_IMG00232-20100618-1221.jpg

th_icon_welder.gif
 
You must log in or register to reply here.
Back
Top