Back where she belongs...

welding fun tomorrow.front jacking point needs some attention along with lower sill and small hole on cab floor.pics to follow
 
Nice job[8D] but the screws aren't straight;)
The millboard headlining in Harvey has warped over the years so will eventually get some attention, what did you use on yours?

th_DCP_9909.jpg

Two's company
 
I used 3mm ply.was going to use millboard but didn't have loads in at work.i just measured the screws again! There level haha.cheers guys.seats to retrim next.being my full time job it helps ;-)
 
Its a brown vinyl we only use it at our place for welting on the hoods but ive always used it for trimming too as all our cars are done in leather! Will pm you where its from etc?
 
You working at your dads tomorrow Aus?
I`m coming to Worcester to collect a crashed car for someone so I might drop in and annoy your folks if I have time:D
 
Just got a picture but it's dark and blurry will put a good one on tomorrow :)
Alan I will be at mine but it's only 20mins away so text dad when your half hour or an hour away and I will pop over (epic journey in the commer) !! :)
 
just had a couple of hours on the van :) took it for a little run over to my girlfriends mothers where it JUST fir in the garage! 1" either side and had two take the roof vent off!
well i cut out and plated up a little bit on the under sill by front jacking point and cut out and plated with 3mm steel on the front side.only got a few pics though as i was in the zone!! haha

few pics

WP_001531.jpg


WP_001530.jpg


WP_001533.jpg



WP_001537.jpg



WP_001535.jpg


seam sealed :)
WP_001538.jpg


undersealed
WP_001540.jpg


well i will re underseal the whole van at some point soon but i want to give her a paint job first :)
 
o yeh nearly forgot I've bought her some new shoes ;)
they are getting collected on tuesday then going straight for the stripes,so probably won't get them for a week or 2 :(
V__3492.jpg


V__6F90.jpg
 
My god, the welding must have taken you days;) Great to see it only need so little - and a great shed to work in[^]
I do like rostyles[8D]

th_DCP_9909.jpg

Two's company
 
haha love a quick blast with welder to be fair.yeh bottom of pass door needs replacement and lower front rhs of valance really at some point.
 
You must log in or register to reply here.
Back
Top