And so to the valence

Over the last few days I've done most of it, as usual it wasn't straight forward:I
The lower valance was rotten and full of filler but the centre section of the fluted part also needed replacing. I decided not to bother with the inner valence panel so chopped it off back to good metal - there was also a small piece that needed letting in.
The piece under drivers side step was also knackered but as I never throw anything out I had some bits to put another one together
Roughly shaped and tacked together
Tacked in place - a bit of dressing up and it should look OK
One half of the valance in place along with the centre section repair
and the other side on
Plenty of cleaning up and a couple of small repairs still to do but not a bad few days work
Member of the Non-Facebook Club