Search results

  1. Saul

    Back of the garage

    That looks and sounds great! good job
  2. Saul

    Cab seat / bed mounts??? How???

    Work for me?!?!?
  3. Saul

    Cab seat / bed mounts??? How???

    Has anybody got a similar seat to mine? I bought it off eBay and it was previously fitted in a commer but I haven't worked out the position of the t bars over the arches. It also doesn't seem to let the engine bay lid come up for access to the radiator when the seat back is on. Any help or...
  4. Saul

    1972 Commer PB

    Photo has a lot more relevance to me than everyone else, but after a load of stress caused with a broken thermostat housing I now have a water type cooling system and everything else back in place (including a new spade plug on the thermostat lead that was frayed) Onto the next...
  5. Saul

    1963 2500

    Hi darren, Message sent. Bazil.
  6. Saul

    1972 Commer PB

    Hi Andrew, MOT was weekend before last and it flew through with no advisories :-) Has been off the road since while I attempt to make it more reliable and address all the little jobs I have put off for a long time. Regarding the repair above, it failed :-( luckily Mr Maltas has been able to...
  7. Saul

    1972 Commer PB

    My neighbour came round to help with the broken bolt. We protected the alternator from heat and then heated up the case around the bolt, bit of wd40 and some mole grips and it came out easily in the end. Next problem was the thermostat housing cover which cracked when reassembling. So I bought...
  8. Saul

    the word game

    Stout
  9. Saul

    Photos of engine bay / fuel pump

    Nearly finished now so I will take plenty of photos before the seats go back. I am trying to document all the oddities I come across on my van.
  10. Saul

    grinding gears

    Could be low clutch fluid level due to a weep from the master cylinder or elsewhere. Lift up the drivers side carpet, un screw the 3 screws and remove the filler cover plate and top up the clutch fluid. If this improves the gear change you have likely lost fluid overtime due to a weep. Can...
  11. Saul

    Urgent! Thermostat housing cover plate

    Just been looking at jb weld, looks strong enough to do the job as long as I use a decent amount of gasket sealant to tighten in to. Back to halfords tomorrow...:-(
  12. Saul

    Urgent! Thermostat housing cover plate

    I might try araldite or similar to start with and try giving it an internal seal with sealant. Maybe some fibreglass resin to beef it up :-( fingers crossed
  13. Saul

    Urgent! Thermostat housing cover plate

    Dammit, apologies, though this gad gone in the wanted section. Making one will be a challenge :-(
  14. Saul

    Urgent! Thermostat housing cover plate

    Has anybody got one they want to sell? Not the housing for the thermostat, it's the end domed cover with two fixing bolts and the top rad hose connects onto. Mine has a hair line crack and sprays water out when temperature is up. I am shropshire area and can travel or will cover postage ...
  15. Saul

    1972 Commer PB

    Thanks for the advice! !! Was going to try the remover drills that screw in anti clockwise and hope it unscrews it
  16. Saul

    1972 Commer PB

    Hillman, commer, sunbeam etc. Looks to be a period replacement for the commer pb original. £28 with free postage off eBay and gives me the other as a spare if needed. Big problem I have now is the perished bolts I am removing from the water pump and thermostat assemblies....and also the broken...
  17. Saul

    1972 Commer PB

    There will be an electric fuel pump at dome point but for now I am stripping the van back to basics. One of the next jobs is to remove the mass of gauges that don't work under the dash. Today's work: Another fuel pump purchased, this time with an offset on the inlet to avoid the oil filter...
  18. Saul

    Commer PB pick up

    My mot tester drove the front wheels into the rollers last Saturday and then couldn't get out again. A couple of us had to push (smaller diameter tyres and an empty back of van)
  19. Saul

    Photos of engine bay / fuel pump

    Hi, Does anybody have some good photos of their engine bays? Seems mine has had various spare parts fitted over the years and I am trying to sort out correct routes and positions within the bay Thanks.
  20. Saul

    1972 Commer PB

    It has now taken a week to get nowhere. And I am fed up. After a crap day at work I still can't install the fuel lines :mad: I found the correct connector (1/4" bsp to 6mm hose) and I loctited and screwed this in the pump. Managed to fit the hose onto the carb (which seems to be an 8mm...
Back
Top