wheels

Ray,

Get bidding on these :p

http://cgi.ebay.co.uk/Rover-P6-Minilite-alloy-wheels-15-upgrade-also-fit-Sd1_W0QQitemZ270558348112QQcmdZViewItemQQptZUK_CarsParts_Vehicles_CarParts_SM?hash=item3efe88c350

I'm assuming these should fit, no problems?

Jon&Cara-Gramarye Fontaine
 
And just like buses.........but a little smaller (14")

http://cgi.ebay.co.uk/6-x-14-Minilite-alloy-wheels-Rover-SD1-Cresta-Sherpa_W0QQitemZ170470450161QQcmdZViewItemQQptZUK_CarsParts_Vehicles_CarParts_SM?hash=item27b0d4a3f1

Jon&Cara-Gramarye Fontaine
 
Just to let you know these 14inch minilites will not fit without 50mm spacers as the wheel will not fit over the drum on the rear, on dodge vans as the brake drums are bigger,will go on the drum of an early commer but fouls the springs! The front also will not fit as the cone on the hub is bigger than the centre bore so needs 45mm spacer or the centre of the wheel machining out. So dont think they will bolt straight on as they wont!;);)
Im in the process of getting some spacers machined up that will bolt to the hub and then have a separate set of studs to bolt the wheel to.So it could also give me the option of making a convertor to change the pcd to fit different wheels.
 
I'm just getting some 15" Jag wheels put on Jon. They were fine on the back but causing a bit of trouble for the front on the PA. Bobby is on the case though and Admins been in touch as he has managed it on his (plus he has a Jag back axle). But what you are saying your having done sounds very handy!

Jon&Cara-Gramarye Fontaine
 
Im going to get something like this machined up for a commer.I looked into some made by H&R a while back but these are to thin they need to be 50mm to get the p5 minilites on.
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=190355021308&ssPageName=STRK:MEWAX:IT
 
You must log in or register to reply here.
Back
Top