Heater Box removal

S

swilli6558

New Member
Hi, this is the first time I have posted.... I'm restoring my PB Autosleeper and am currently on a weldathon. The heater box has disintegrated (not unusual) and I will need to get the heater and box out.
I'm not sure how to remove the small grill on the frot to gain access to the bolts that hold the heater box on, does it 'just' unclip? or am I missing something?

Cheers all,
Shaun
 
Hi there and welcome.as by chance I took mine off yesterday to spray the front end of the van if you look inside there are 5/16 nuts one at each end then there are 4lugs that push into plastic clips two at top two at the bottom then behind it you will find Phillips screws that I think hold the heater in.my inside was covered in anti vibration mats so had to dig about to find them good luck
 
I saw those nuts after I posted the message and thought that was the answer, I'll see if thay can be persuaded to undo!!
I saw Martin can supply a new box, might be a lot easier then me trying to fix mine...... thanks again......
 
You must log in or register to reply here.
Back
Top