Drawings for front seat/bed

booglissamo

booglissamo

Member
Any design drawings available for the standard front rock and roll type front seats in a PB accounting for the engine bulkhead and for that bulkhead to be accessed with support for the driver & passengers footwell?

If I can't get the old, I'll look at fabricating new perhaps...
 
I may be wrong (he is away now to Spa for a few days) but I think Austin may have a front bench seat you may be able to get a few dimensions off.
 
We have front bench seat that goes to bed. It isn't quite 'original' and we use a bit of foam to 'level it'. Basically it has a back rest that sits in brackets on the base and is fully detachable. The seat base 'slides' over the frame with a locking pin to stop it sliding when driving. I think it originally hooked on the bottom dash shelf. It has a cut out for gear stick. You can't access the engine cover without removing rear of seat but then the base slides forward then hinges up to give access to engine cover. Rubbish description I know.
 
Yes does sound a bit confusing. I guess I need to actually see any one to understand how yours worked. Mine we replaced with two modern seats somewhere along the line and I want to change back, for one, alone just to be in a better driving position as well. I will investigate ta :)
 
You must log in or register to reply here.
Back
Top